What are the steps to replace the shower seal? The following liquid silica gel manufacturers will introduce it to you in detail:

The shower seal is a simple and necessary structure to prevent large amounts of water from escaping and damaging the surrounding building materials during the shower. The sealing material is cracked and inflexible, so it may not have a reasonable time to work. Sometimes the sealing adhesive on the door may fail and damage the seal, while the good news is that replacing the seal strip is a simple and small project that can be completed in minutes.

How do I replace the shower seal

1. The silicone rubber strip manufacturer introduces removing the damaged gasket or what is on the left or right side of the adhesive, and gently and slowly pulling the joint. If necessary, use a plastic putty knife to push the seal and wide glue carefully not to scratch the shower door.

2, with a clean cloth dipped in alcohol or with adhesive solvent such as goo disappear or peel off the rub residue, if this thing will not be useful for their work. Wash the area with a mild detergent and warm water, dry thoroughly before continuing.

3. Dry the new seal on the door and cut the cut gasket if necessary. Rubber seal back by pressing the surface of the door at one end to start the smooth connection at the other end. On the joints with no back glue, run a silicon bead along the door by pressing it into seals from one end even into other silicon.

4, silica gel sealing ring manufacturer points out that clean up the excess silica gel leakage with a clean wet cloth joint. Allow silica gel to dry and harden at least 36 hours before use in showers and exposure to water.